Stage Ape Lighting Stage Ape Lighting





stage ape

stage ape

Read Our Warranty
and Store Policies.

Click Here!
stage ape
The Ape JUNGLE-HAZE1200... (Replaced by the HAZE-1201)
This product is DISCONTINUED. There are no more in stock and none available. This info is here for customers that purchased this item in the past and need details or instructions.

1200 Watt DMX continuous hazer.

Includes wireless and Timer Remotes with adjustable output volume knob for the wired remote, Duration knob, Continuous flow button, Timer button and Manual button. 16 foot cable on remote.

1 channel DMX.

15,000 cubic feet per minute. 1.5 liter tank. Adjustable 45 to 75 degree vertical output vent so you can aim the haze straight out or up.

3 minute initial warm up time with 5 to 25 second reheat time. Uses standard fog fluid, or for a longer hang time, use our H-ProSmoke.

 Unit size 22x11x9.5 15.3 lbs.

Download Instruction Manual as a PDF file HERE.

The video below shows the JUNGLE-HAZE1200 starting on the lowest visible setting and gradually increasing the volume to the maximum.

Jungle Haze 1200
stage ape **SOLD PRIOR TO JULY 2012** stage ape

Instructions for operation:

Fill the 1.5 liter tank with standard (water based) fog fluid. There is a tube that leads from the top of the tank into the machine (make sure it's suction end rests at the bottom of the fluid tank). Flip the power switch on the rear of the unit. The switch lights up red and begins the initial warm up time of about 3 minutes. The 16' wired controller plugs into the 5 pin input on the rear of the unit. Adjust the vent in the front of the unit to disperse fog straight out along the ground or adjust it up to spray fog into the air.

The controller consists of 3 buttons marked differently with led indicators above each button. The buttons control the modes and 3 knobs above the buttons control the features in each mode.

Jungle Haze 1200
Manual Mode

The right button is the manual fog button. The manual button has the green light above it to let you know when the fogger is ready to dispense fog (after each complete burst the green light will go off until the fogger has reheated). You cannot control the output in manual mode.

Continuous Mode

The middle button is the continuous fog button. In this mode, when the fogger has reached it's ready temperature, the it will automatically start blowing fog. The knob above marked "output" controls the amount of fog that it dispenses. All the way to the left is none and turn clockwise to desired output. Always start with the volume knob fully clockwise and gradually turn the knob counter-clockwise because the fog decreases to zero slightly before the knob reaches full off (full counter clockwise).
Jungle Haze 1200
Timer Mode

The button marked "Timer" lets you set the fogger to to dispense fog in certain set intervals. Use the knob marked "Interval" to adjust time between blasts. The interval knob goes from 10 seconds to 200 seconds. Ten seconds is all the way to the left, turn clockwise to increase the time between blasts. Use the output knob to set the output to desired volume. The Duration knob controls how long the blast will go on after the fogger has started blowing fog out. Turn the knob clockwise for the longest blast, turn it counter clockwise to shorten the length of time the fogger will dispense fog.
Jungle Haze 1200
DMX Mode

After connecting your fogger to your DMX controller using a DMX cable, set the dip switches according to there location in your DMX chain. This fogger is a 1 channel DMX fixture so the 1st slider controls the volume of fog that it will dispense. Slide the slider all the way up for the most output.
Jungle Haze 1200
Includes black power cord. cord


  2010 by Stage Ape Lighting